Description

Note: ● Fitment system may not be 100% accurate, if you are not sure which bulb size you need, please check vehicle manual or stock bulb model. This listing compatible with 2 pairs (9008+5202) 6000K white super bright LED headlight high/low beam + fog light bulbs conversion kit. Headlight Bulbs Specifications: ● Bulb Socket: 9008 , high-Low beam ● LED Quantity(each bulb): 2pcs* chips, 2-sides ● Technology: LED ● Connector(s): plug and play ● Operating Voltage: DC 9V ~ 32V , Fit for 12V & 24V vehicle. ● Wattage: 40W per bulb ● Luminous Flux: 4000 LM per bulb ● Color temperature: 6000K ● Light color: Cool White ● Material: Aviation 6063 aluminum profile ● Beam Angle: 360 degree ● Operating Temperature: -40-85 degree Celsius ● Waterproof Rate: IP67 rated Waterproof and dust seal, works well even in extreme weather ● Lifespan: over 50000 hours life time, stable quality and long service life Headlight Bulbs Features: Extremely bright LED chip,360 degree clear beam no blind zone Engineering beam pattern design throw light on road evenly at appropriate angle without foggy light Xenon white light reflect road paint/signs better to show clearer road situation Built-in constant current CPU,instant full brightness without start-up relay Easy plug and play design, no resistor or modification needed. The bulb body size of our bulb is smaller than other four-sided LED bulbs on the market, no need to worry about interference with the dust cover. Fog Light Bulbs Specifications: ● Bulb Size: 5202 ● Voltage: DC 12V-24V ● High Power: 40W per bulb ● Luminous Flux: 4000 LM per bulb ● LED Type: CSP 3013 chips ● Color: 6000K Xenon White ● Beam Type: 360° Beam Angle ● Material: Aaluminum profile ● Long-lasting Lifespan 50000 Hours ● Plug and Play Easy Installation ● Fast on/off Response Time and Vibration Resistant Package Include: ● 2x 9008 LED headlight bulbs ● 2x 5202 LED fog light bulbs ● New and old packaging will be shipped randomly Install Caution: ● As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process. ● Put the vehicle into park or make sure it is securely in gear. ● Make sure to have the ignition turned off and the keys removed. ● Be careful to avoid burns, especially when turning on or off the vehicles lighting. ● Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting. ● Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems. ● Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb. WARNING ABOUT POLARITY Unlike halogen bulbs, LED are polarity sensitive. BEFORE you start your LED kit installation, verify the polarity on your vehicle by simply plugging the LED bulb into your vehicle socket. - if your light turns on, please proceed to install both bulbs onto your vehicle. - if your light DOES NOT turn on, disconnect the bulb and flip the socket in order to reverse the polarity (this will not damage your vehicle electrical system in any way). Once you made sure the LED bulb turns on, please proceed to install both bulbs onto your vehicle. Note: There is no convention when it comes to polarity. Different car manufactures have different polarity setup, even within the car model the polarity setup on your low beams and high beams might be different.